Quick Set

DESCRIPTION:

AT-QUICK SET is an extra quick setting waterproofing compound to seal water infiltrations. When mixed with cement, it sets immediately to check severe water infiltration.

USES:

• AT-QUICK SET is used to seal infiltrations and plugging wet cracks in concrete and masonry surfaces.
• It can also be used as a Quick Setting admixture for concrete repair.

ADVANTAGES:

• AT-QUICK SET is an effective compound for severe water infiltration in concrete, rock and masonry. Key benefits are:
  • Easily hardens under continuous wet conditions
  • Acts as an effective crack sealer in concrete and masonry surfaces
  • Sets immediate contact with cement
  • Can be used to fix nozzles for grouting
  • Ready to use
  • Chloride free

INSTRUCTION FOR USE:

• Remove all loosely adhering particles.
• Then add AT-QUICK SET with cement at recommended dosage and hold it against the source of leakage.
• Remove hand/finger slowly from the source after 15-20 seconds.
• Please note that permanent repairs should be carried out by using AMPL’s other product range.

RECOMMENDED DOSAGE & USAGE GUIDELINES:

• Mix 1 part of AT-QUICK SET with 2 parts of Portland cement by volume.

TECHNICAL DATA:

PACKAGING & STORAGE:

• AT-QUICK SET is available in the following pack:
  • 1 kg / 5 kg / 25 kg / 250 kg PACK
• Storage condition above 10ºC
• Shelf life is 12 months in sealed containers as provided
• Protect AT-QUICK SET from direct sunlight
• Keep containers sealed and away from heat and cold in a well ventilated area
• Stir material well before use

HEALTH & SAFETY:

• Protect hands with rubber gloves and eyes with goggles.
• Accidental splashes to the skin or eyes must be rinsed immediately with clean water.
• Store in well-labeled containers.
• If required get medical attention.