Anticor S-210

DESCRIPTION:

AT-ANTICOR S 210 is a cement-based anti-corrosive protective coating formulated to inhibit the corrosion of reinforcing steel.

USES:

AT-ANTICOR S 210 is used in the following situations:

• Reinforcing bars
• Corroded reinforcement in reinforced/ pre-stressed concrete

ADVANTAGES:

• Excellent adhesion to steel
• Good bonding coat for subsequent cement based repair mortar
• Good barrier effect against water, chloride and carbon dioxide
• Easy to use, available in pre packed kit

COVERAGE:

• Depending on the type of application, 2 coats are recommended
• The average consumption is ~ 3.0 – 3.5 kg/m² for 2 coats

INSTRUCTIONS FOR USE:

• SURFACE PREPARATION: The steel surface has to be cleaned from laitance, loose rust particles, oil and grease. The cleaning could be done by sand blasting or by using hard steel brush.
• MIXING: Pour Component A (Liquid) into a suitable mixing container and add the proportioned quantity of Component B (Powder).
• APPLICATION: While applying on corroded steel surface, surrounding concrete should be saturated surface dry. AT-ANTICOR S 210 has to be applied on the prepared steel surface using a hard bristled brush. It is unavoidable, that while application on steel, some coating may also get applied on the concrete surface, which is by no means a disadvantage.

   TECHNICAL DATA:

PACKAGING & STORAGE:

• AT-ANTICOR S 210 is available in :
  • Component A = 250 g (LIQUID)
  • Component B = 01 kg (POWDER)
• Shelf life is 06 months in original & sealed packing
• Storage condition should be free from frost and protect from direct sunlight
• Keep packing in cool, dry place away from heat, cold and moisture

HEALTH & SAFETY:

• Protect hands with rubber gloves and eyes with goggles.
• Accidental splashes to the skin or eyes must be rinsed immediately with clean water.
• Store in well-labeled containers.
• If required get medical attention.