Tile Fix 10

DESCRIPTION:

AT-TILE FIX 10 is a ready-to-use cementitious, waterproof, self cured tile adhesive. AT-TILE FIX 10 has good adhesion and water resistant properties which is not affected by the presence of moisture.
USES:

• AT-TILE FIX 10 is suitable for interior and exterior bonding of most basic types of Ceramic wall and floor tiles bonded to concrete cementitious screeds, brickwork, block work and where surfaces are rigid and exhibit some surface texture porosity.
• AT-TILE FIX 10 is suitable for thick or thin bed tile installation.

ADVANTAGES:

• AT-TILE FIX 10 is especially suited to high performance situations. Key benefits are:
  • Ready-to-use, only water needs to be added
  • Gives stronger bond than conventional cement-sand mortar
  • Self-curing
  • Since AT-TILE FIX 10 is polymer modified hence it has high waterproofing properties
  • Wetting of tiles is not required
  • Chloride free

INSTRUCTION FOR USE:

• Surface to be treated; should be sound and free from any contaminations.
• After preparation of the surface, it should be wetted to make a saturated surface dry condition.
• After mixing AT-TILE FIX 10 in the ratio of 3:1 (AT-TILE FIX 10 : WATER) a thin bed of approximately 3 mm is applied and spread with a notched trowel.
• The tile is to be placed firmly into position by twisting action.
• Excess adhesive from the tile surface should be removed using damp cloth.
• The concrete has to be cured for a minimum of 3 days by wet gunny bag or ponding with water.

TECHNICAL DATA:

PACKAGING & STORAGE:

• AT-TILE FIX 10 is available in the following pack:
  • 30 kg bag
• Shelf life is 12 months in sealed condition as provided
• Protect AT-TILE FIX 10 from direct sunlight
• Keep containers sealed and away from heat and cold in a well ventilated area

NOTES ON APPLICATION / LIMITATION:

• Cementitious substrates must be at least 28 days old.
• Do not exceed the recommended water dosage. Apply only on sound, prepared substrates. Do not exceed the maximum layer thickness.
• Plaster substrates must have a minimum thickness of 10 mm
• Protect freshly applied material from freezing, rain, etc.
• Place tiles within 15 minutes of mixing and place firmly with twisting movement.
• Uneven surface may require more than 3 mm thickness.
• Use damp cloth to remove excess paste from the tile surface.

HEALTH & SAFETY:

• Protect hands with rubber gloves and eyes with goggles.
• Accidental splashes to the skin or eyes must be flushed immediately and repeatedly with fresh water, if required get medical attention.
• Keep out of the reach of children.
• Store in well-labeled containers.