×
  • +91 33 4001 73 13
  • response@adochemicals.com

Ferro Coat

DESCRIPTION:

AT-FERRO COAT is single component, water based, protective coating against corrosion for Steel Structures used in concrete and Pipes etc.

USES:

  • AT-FERRO COAT is mainly used as a corrosion inhibiting coating, applied on concrete, reinforcement of steel surfaces, pipes etc.

CHARACTERISTICS:

COLOUR White
COVERAGE (2 kg Cement + 1 kg AT-FERRO COAT) 2-2.5 Square Meter
APPLICATION TEMPERATURE Above 10°C
APPLICATION By Brush, Rollers of Spray Guns
MIXING RATIO (Cement : AT-FERRO COAT) 2 : 1 by weight

 

 

 

 

ADVANTAGES:

  • Easy to apply
  • Can be applied in moist surfaces
  • Allow vapour pressure to pass through the coating their by prevent the formation of blistering of the coating
  • Provide a dust free surfaces
  • Keeps the adhering concrete alkaline in RCC

APPLICATION:

  • For reinforcing steel bars
  • Corrosion Protective coating for concrete or steel structures.
  • Sheet metal
  • Outside of tanks
  • Lawn equipment
  • Bond Coat for Concrete with steel and/or reinforcement.

APPLICATION METHODOLOGY:

  • Remove dust, flakes, or other foreign particles by jet or dry air and clean the surface mechanically or with wire brush to ensure removal of loose rust particles.
  • Two part of Fresh Cement to be added with one part of AT-FERRO COAT by weight.
  • Apply the mixed material to the prepared surface by means of Brushes, Rollers or Spray Guns.
  • Apply second coat once the first coat is touch dry.

TECHNICAL INFORMATION:

FORM Liquid
COLOUR White
SPECIFIC GRAVITY AT 30°C Around 1.04
pH 7-9
CHLORIDE CONTENT (As per BS 5075, Part I) NIL

 

 

 

 

PACKAGING & STORAGE:

  • AT-FERRO COAT is available in the following pack:
    • 5 kg & 20 kg
  • Shelf life is 12 months in sealed containers as provided @ 300C
  • Keep containers sealed and away from heat and cold in a well ventilated area

HEALTH & SAFETY:

  • Use goggles, mask, nose cover and hand gloves during application.
  • Clean hands with warm soap water after application.
  • Avoid contact with skin / eyes.
  • In case of unlikely contact with eyes, rinse immediately with plenty of clean water, then cleanse with soap and lukewarm water and seek medical advice.
  • Do not use solvent to clean the contacted area.
  • Ensure adequate ventilation and avoid inhalation of vapours as some people are sensitive to resins, hardeners and solvents.
  • If swallowed seek medical attention immediately. Do not induce vomiting.